Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
D002 - Can you please explain what this specification implies. Because the typical value is Vss.
What I understand is that, POR will be released when VDD is > Vss. Which means, whenever VDD is > VSS, POR goes High and RESET is deasserted. In that case, What would be the voltage on the RESET pin?
Ok, so once the VDD supply reaches VDD = 1.8V, the RESET is released by the device?
1704425154
This line is not clear, "The on-chip POR circuit holds the device in Reset untilVDD has reached a high enough voltage to deactivatethe POR circuit".
How does high enough imply? What voltage can be...
I would actually like to know what is the POR level for this IC.
Suppose, my power supply VDD, is 3.3V. And if I turn off the supply, it takes time to reduce. Slowly, it comes to 3V, 2.5V, 2.2V, 1.2V ... and then 0V. What happens suppose, when the decreasing voltage is around, say 1.2V, and at...
In this datasheet, page 1, block diagram, why is the VDD connected to POR?
1. Why is the VDD connector to POR?
2. Is there POR for this IC? I couldn't find the value on the datasheet.
I found the 1us - TABLE 2-1, page 24. Is this 1us POR?
3. Since POR block is connected to VDD? How should I...
Thank you for the answer. But this doesn't seem to have an internal regulator as seen in Figures on page 2 of the datasheet.
Also, so you mean to say, by giving the 12V input to this section, I have damaged the IC?
Also, How is the feedback 10k affecting this Vcc input? (Actually, the RESET...
Can you please tell me why the 143k in series is not helping?
How alternate method will help? Where should I put the zener?
1702304688
Can you please tell me how does the IC not supposed to start-up with this 143k combination? Anyway, the input voltage should be available at the Vcc pin, right?
I am not saying there is not 12V at pin 4. I am saying the 12V is there present at the top of the R102 resistor. But only 0.8V at the pin 4 of the IC.
I am not calculating. I am testing the circuit in the test bench.
Thank you for your answer.
Just a couple of questions from your answer.
1. Can you please explain how increasing the top resistor value will make the ADC more prone to noise and slow down the response time?
2. What can be the value of the capacitor that I can place on the ADC input to...
Below is a circuit I have.
Initially, I have 2 100k resistors. And the node will be given to an ADC in an MCU. But since the ADC requirement was modified later, the bottom resistor was changed to 10k.
But this increased the sleep current due to the low value resistor. Hence, can you please...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
